First of all, consider the stages of measurement pomescheniyMontazh profilyPodgotovka mounting point for the installation of lamps svetilnikovMontazh polotnUstanovka Some features of working with stretch ceilings As soon as the cloth got, take it out of the box and put it in a warm room, if brought in from the cold, without removing at the same packing material. Do not put anything on top the canvas. All ceilings width greater than 135 cm, have a welded seam. This seam is performed at the factory on special machines. Welds are made at intervals of 130, 150, 200 cm, depending on the type of film. Stitches are needed in this case, since the seamless production, in this If not already exist. A computer program can place the welds, relatively light, almost invisible. During manufacture, the ceiling is reduced by about 4-6%, it allows you to stretch canvas when heated.

It does not give sagging canvas. If the ceilings are high, an area greater than 60m2, it is recommended to put the dividing sections. Stretch ceiling is set at 3 cm below the baseline. Mounting tension ceiling does not take much time, for example, in a room 20 square meters, has a chandelier, ceiling installation will take approximately 5 hours. How does the installation around the perimeter is fixed by molding to the walls of the drilled holes at a distance of 15-20 cm, all depends on the quality of the walls. Only one lamp unit with a rack and termokoltsom PVC takes 40-60 minutes.

Before you start assembling the ceiling, make a preliminary calculation. If you start to add the cost of metering for nails, etc. .. is it worth to believe such firms? Lights in the ceilings – how to install when installing suspended ceilings there are some features, such as the use of light sources. And here at once necessary notice that the wattage should not exceed 50 watts, halogen and if – then no more than 35W, otherwise the fabric will stretch just, will sag from the heat.